Mounting Height
For all the Combi models the mounting height is based on the distance from the warm air outlet of the hand drier to the floor which is recommended at 1200mm – 1400mm.

This is equivalent to the bottom of the front panel of the BC1 or BC2 being 350mm – 550mm above floor level.

For the BC3 and BC4 this measurement is 850mm – 1050mm.

These dimensions may be modified to suit installation conditions.

Installation
All four Combi models are pre-drilled in the rear box for screw or bolt fixings. The location should be inspected for structural integrity and if in doubt consult a qualified engineer, surveyor or builder.

Fixing holes are designed for M10 or 3/8” diameter fixings.

Cabinet
The rear cabinet of the BC1 and the BC3 is made from mild steel and finished black stoved enamel. Waste receptacles are of black plastic coated wire mesh. The rear cabinet of the BC2 is made of stainless steel. Two keys are supplied with each lock.

Finish
All four models utilise a heavier gauge stainless steel than most other models available.

Each model is also available in a polyester powder paint finish – white RAL 9010 90%.

Electrical (for BC1, BC2 and BC3)
The in-built Hand Dryer is automatic and is pre-wired to a terminal block via a microswitch. The microswitch prevents the Hand Dryer operating when the front panel is opened. Cable entry is via a 20mm knock out on the right side.